25/02/2017
livesupport   twitter   facebook   linkedin

 
 
A-frame Condenser More details  

A-frame Condenser

An air cooled condenser for liquefying vacuum steam downstream a steam turbine.
 
 
 
Air-cooled acid gas coolers More details  

Air Cooled Cooler

A device in which a fluid is cooled by ambient air; the fluid is separated from the air by finned tubes.
 
 
 
Air-cooled heat exchangers More details  

Air Cooled Heat Exchanger

A device in which a fluid is cooled by ambient air; the fluid is separated from the air by finned tubes.
 
 
 
Air heater More details  

Air Heater

A device in which process air (f.i. for drying processes) is heated by means of steam or another hot fluid. Economisers
This product can be applied in the following processes:
 
 
 
Boiler More details  

Boiler

A fired heater in which a fluid- usually water – is vaporised.
This product can be applied in the following processes:
 
 
 
Radiax impression More details  

Centrifugal Pump

A piece of equipment that increases the pressure of a liquid. Radiax application under construction
This product can be applied in the following processes:
 
 
 
Compact Header More details  

Compact Header

To avoid extreme heavy channels on high pressure heat exchangers Bronswerk has developed this Compact Header.
This product can be applied in the following processes:
 
 
 
Compressor skid More details  

Compressor

A piece of equipment for increasing the pressure of a gas. Radiax application under construction
This product can be applied in the following processes:
 
 
 
Condenser More details  

Condenser

A device in which a fluid - a vapour - is liquefied in full or part. Condenser, Surface condenser, Rendering Steam Condenser, A-frame condenser
 
 
 
Coolers More details  

Cooler

A device in which the main fluid is cooled down by a secondary flow, which is heated. Cooler, Subsea cooler, water-cooled cooler, gas cooler, Air-cooled cooler
This product can be applied in the following processes:
 
 
 
Oil Heat Exchangers More details  

Crude Oil Heat Exchanger

A device in which Crude Oil is heated and/or cooled. At least one of the fluids is Crude Oil, but it is also possible that both fluids are Crude Oil.
This product can be applied in the following processes:
 
 
 
System More details  

Dumpcondensation System

A dump condenser is required when the steam consumption needs to be drastically reduced in a very short period of time and when the boiler cannot follow this variation. Bronswerk has developed a ingenious control system for air cooled dump condensers.
This product can be applied in the following processes:
 
 
 
Evaporator More details  

Evaporator

This is a device in which a liquid is fully or in part vaporised.
This product can be applied in the following processes:
 
 
 
Heat Exchanger More details  

Falling Film Evaporator

A heat exchanger with vertical tubes, where a fluid is partially evaporated while flowing as a thin film downward on the heated tube-wall.
 
 
Heat Exchangers More details  

Heat Exchanger

A device in which energy (heat) is transferred from a hot fluid to a colder fluid. The fluids are separated by a wall, and cannot mix.
 
 
 
Water heaters More details  

Heater

Heating is normally performed by hot thermal oil, hot water or steam, or electrically.
 
 
Gas heater More details  

Natural Gas Heater

A heat exchanger in which natural gas is heated by means of warm water or steam. This is normally done in gas pressure reducing stations, where gas decreases in temperature due to reduction of pressure.
This product can be applied in the following processes:
 
 
 
Air-pre heater More details  

Pre Heater

A device in which a liquid is heated from a sub-cooled temperature to its evaporation temperature. An evaporator is often the device upstream the pre heated liquid.
This product can be applied in the following processes:
 
 
 
reboiler More details  

Reboiler

In a reboiler a fluid is fully or in part evaporated. The device is often placed at the bottom of a distillation column, so that the fluid, after being liquefied again, enters the reboiler again and again. A kettle reboiler is a widely used type.
This product can be applied in the following processes:
 
 
 
Reflux condenser More details  

Reflux Condenser

A device in which a vapour is liquefied. The vapour flows up, whereas the formed liquid flows down by gravity, opposite to the vapour flow. Subcooling ( and therewith the chance on freezing) is avoided, and gasses can well be separated from the condensate.
This product can be applied in the following processes:
 
 
 
Reheater More details  

Reheater

When the wetness in a steam turbine would be too high at outlet, the steam is extracted halfway the turbine at a mid-pressure. At this pressure the temperature of the steam is strongly increased, and then the steam can enter the turbine again and further expand, without danger for too much condensate.
This product can be applied in the following processes:
 
 
 
separator More details  

Separator

A device in which two immiscible fluids are separated.
 
 
 
Steam generator More details  

Steam Generator

A boiler in which water is transferred to steam, often unfired, with a hot fluid as heating source.
This product can be applied in the following processes:
 
 
 
Burners More details  

Submerged Combustion Burner

A special high pressure burner used in LNG vaporation process installations.
This product can be applied in the following processes:
 
 
 
subsea cooler More details  

Subsea Cooler

An oil or gas cooler where seawater is used as coolant. The cooler is mounted sub-sea, and the water flows due to natural draft only.
This product can be applied in the following processes:
 
 
 
sulphur condenser More details  

Sulphur Condenser

A cooler/condenser in the process of desulphurisation of crude oils. The vapour in the exchanger partly condenses; this condensate has an extreme high sulphur content. To avoid damage to the equipment the channels are often provided with protecting concrete. Solidification of sulphur is avoided by tracing.
This product can be applied in the following processes:
 
 
 
Super Heater More details  

Superheater

When in a boiler or vaporiser a liquid is evaporated, the vapour might need to be superheated to make sure that no wetness can occur in the flow.
This product can be applied in the following processes:
 
 
 
vessel More details  

Vessel

This is a container for process fluid.
This product can be applied in the following processes:
 
 
 
Boiler More details  

Waste Heat Boiler

A boiler where a liquid – often water – is evaporated. It is not a fired heater, the heating fluid is a gas or liquid at high temperature that has been named and treated as “waste” in the past.
This product can be applied in the following processes:
 
 
 
waste heat boiler More details  

Waste Heat Boiler High Temperature

A special boiler where a liquid – often water – is evaporated. Because of the very high temperature special precautions are required.
This product can be applied in the following processes:
 
 
 
Whizz Wheel Fan 3 More details  

WhizzWheel® Fan

WhizzWheel® Fan for Air-cooled coolers
 

Sitemap
 
Hide
 

Contact

The Netherlands

Russia

Czech Republic

Main office
Stationsweg 22 P.O. Box 92 Phone: +31 33 24 72 500
3862 CG Nijkerk 3860 AB Nijkerk Fax: +31 33 24 52 338
The Netherlands The Netherlands Email: info@bronswerk.com
Smolenskaya Square 3 Phone: +7 495 775 1060
121099 Moscow Fax: +7 495 775 1061
Russia Email: info@bronswerk.ru
Děčínská 288 P.O. Box 14 Phone: +420 412 590 511
407 22 Benešov nad Ploučnicí 407 22 Benešov nad Ploučnicí Fax: +420 412 586 340
Czech Republic Czech Republic Email: info@bronswerk.cz
Service & Maintenance
Seggelant-Noord 5D Phone: +31 18 17 45 500
3237MG Vierpolders Email: service@bronswerk.com
The Netherlands
Dutch contact map
Czech contact map
Russisch contact map
© Bronswerk   Privacy statement   Terms & Conditions   Disclaimer
website by Fenêtre + gaudi
2